Armagard Controller Board Setup V2
Posted by Production Team, Last modified by Production Team on 03 July 2018 14:35

This is the manual for the Armagard Standard V2 Controller Board. The V2 controller boards have a 20-pin connector. If your controller board has a 3-pin connector, you will need to use the V1 controller board manual:

 Controller Board Setup - Standard V2.pdf (692.72 KB)
(1 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please complete the below captcha challenge (we use this to prevent automated submissions).