Armagard Controller Board Setup V1
Posted by , Last modified by Production Team on 03 July 2018 14:34

This is the manual for the Armagard Standard V1 Controller Board. The V1 controller boards have a 3-pin connector. If your controller board has a 20-pin connector, you will need to use the V2 controller board manual: 

 controller board setup - standard.pdf (611.96 KB)
(0 vote(s))
Not helpful

Comments (0)
Post a new comment
Full Name:
CAPTCHA Verification 
Please complete the below captcha challenge (we use this to prevent automated submissions).