Armagard Controller Board Setup V1
Posted by Richard Hawkesford, Last modified by Technical Support on 03 July 2018 14:34


This is the manual for the Armagard Standard V1 Controller Board. The V1 controller boards have a 3-pin connector. If your controller board has a 20-pin connector, you will need to use the V2 controller board manual: https://support.armagard.com/index.php?/Knowledgebase/Article/View/54/9/armagard-controller-board-setup-v2 



Attachments 
 
 controller board setup - standard.pdf (611.96 KB)
(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please complete the below captcha challenge (we use this to prevent automated submissions).